✨ RGB_STARTUP_TEST

Marlin/Configuration.h

@@ -3251,16 +3251,19 @@
  * luminance values can be set from 0 to 255.
  * For NeoPixel LED an overall brightness parameter is also available.
  *
- * *** CAUTION ***
+ *  === CAUTION ===
  *  LED Strips require a MOSFET Chip between PWM lines and LEDs,
  *  as the Arduino cannot handle the current the LEDs will require.
  *  Failure to follow this precaution can destroy your Arduino!
+ *
  *  NOTE: A separate 5V power supply is required! The NeoPixel LED needs
  *  more current than the Arduino 5V linear regulator can produce.
- * *** CAUTION ***
  *
- * LED Type. Enable only one of the following two options.
+ *  Requires PWM frequency between 50 <> 100Hz (Check HAL or variant)
+ *  Use FAST_PWM_FAN, if possible, to reduce fan noise.
  */
+
+// LED Type. Enable only one of the following two options:
 //#define RGB_LED
 //#define RGBW_LED
 
@@ -3269,6 +3272,10 @@
   //#define RGB_LED_G_PIN 43
   //#define RGB_LED_B_PIN 35
   //#define RGB_LED_W_PIN -1
+  //#define RGB_STARTUP_TEST              // For PWM pins, fade between all colors
+  #if ENABLED(RGB_STARTUP_TEST)
+    #define RGB_STARTUP_TEST_INNER_MS 10  // (ms) Reduce or increase fading speed
+  #endif
 #endif
 
 // Support for Adafruit NeoPixel LED driver