Bring configs and drivers.h up to date

Marlin/Configuration.h

@@ -143,7 +143,7 @@
 // @section extruder
 
 // This defines the number of extruders
-// :[1, 2, 3, 4, 5, 6]
+// :[1, 2, 3, 4, 5, 6, 7, 8]
 #define EXTRUDERS 1
 
 // Generally expected filament diameter (1.75, 2.85, 3.0, ...). Used for Volumetric, Filament Width Sensor, etc.
@@ -412,6 +412,8 @@
 #define TEMP_SENSOR_3 0
 #define TEMP_SENSOR_4 0
 #define TEMP_SENSOR_5 0
+#define TEMP_SENSOR_6 0
+#define TEMP_SENSOR_7 0
 #define TEMP_SENSOR_BED 0
 #define TEMP_SENSOR_PROBE 0
 #define TEMP_SENSOR_CHAMBER 0
@@ -441,6 +443,8 @@
 #define HEATER_3_MINTEMP   5
 #define HEATER_4_MINTEMP   5
 #define HEATER_5_MINTEMP   5
+#define HEATER_6_MINTEMP   5
+#define HEATER_7_MINTEMP   5
 #define BED_MINTEMP        5
 
 // Above this temperature the heater will be switched off.
@@ -452,6 +456,8 @@
 #define HEATER_3_MAXTEMP 275
 #define HEATER_4_MAXTEMP 275
 #define HEATER_5_MAXTEMP 275
+#define HEATER_6_MAXTEMP 275
+#define HEATER_7_MAXTEMP 275
 #define BED_MAXTEMP      150
 
 //===========================================================================
@@ -678,6 +684,8 @@
 //#define E3_DRIVER_TYPE A4988
 //#define E4_DRIVER_TYPE A4988
 //#define E5_DRIVER_TYPE A4988
+//#define E6_DRIVER_TYPE A4988
+//#define E7_DRIVER_TYPE A4988
 
 // Enable this feature if all enabled endstop pins are interrupt-capable.
 // This will remove the need to poll the interrupt pins, saving many CPU cycles.
@@ -1044,6 +1052,8 @@
 #define INVERT_E3_DIR false
 #define INVERT_E4_DIR false
 #define INVERT_E5_DIR false
+#define INVERT_E6_DIR false
+#define INVERT_E7_DIR false
 
 // @section homing
 
@@ -1429,11 +1439,6 @@
 #define DEFAULT_KEEPALIVE_INTERVAL 2  // Number of seconds between "busy" messages. Set with M113.
 #define BUSY_WHILE_HEATING            // Some hosts require "busy" messages even during heating
 
-//
-// M100 Free Memory Watcher
-//
-//#define M100_FREE_MEMORY_WATCHER    // Add M100 (Free Memory Watcher) to debug memory usage
-
 //
 // G20/G21 Inch mode support
 //