new config model

git-svn-id: svn://svn.coreboot.org/coreboot/trunk@1797 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1

targets/motorola/sandpoint/Config.lb

@@ -2,75 +2,9 @@
 # the Altimus mpc7410 PMC card
 # This will make a target directory of ./sandpoint
 
-loadoptions
-
 target sandpoint
 
-uses CROSS_COMPILE 
+mainboard motorola/sandpointx3_altimus_mpc7410
-uses HAVE_OPTION_TABLE
-uses CONFIG_SANDPOINT_ALTIMUS 
-uses CONFIG_COMPRESS 
-uses DEFAULT_CONSOLE_LOGLEVEL 
-uses CONFIG_USE_INIT
-uses CONFIG_CHIP_CONFIGURE
-uses NO_POST
-uses CONFIG_CONSOLE_SERIAL8250 
-uses TTYS0_BASE 
-uses CONFIG_IDE
-uses CONFIG_FS_STREAM 
-uses CONFIG_FS_EXT2
-uses CONFIG_FS_ISO9660
-uses CONFIG_FS_FAT
-uses AUTOBOOT_CMDLINE
-uses PAYLOAD_SIZE
-uses ROM_SIZE
-uses ROM_IMAGE_SIZE
-uses _RESET
-uses _EXCEPTION_VECTORS
-uses _ROMBASE
-uses _ROMSTART
-uses _RAMBASE
-uses _RAMSTART
-uses STACK_SIZE
-uses HEAP_SIZE
-
-## use a cross compiler
-#option CROSS_COMPILE="powerpc-eabi-"
-#option CROSS_COMPILE="ppc_74xx-"
-
-## Use stage 1 initialization code
-option CONFIG_USE_INIT=1
-
-## Use static configuration
-option CONFIG_CHIP_CONFIGURE=1
-
-## We don't use compressed image
-option CONFIG_COMPRESS=0
-
-## Turn off POST codes
-option NO_POST=1
-
-## Enable serial console
-option DEFAULT_CONSOLE_LOGLEVEL=8
-option CONFIG_CONSOLE_SERIAL8250=1
-option TTYS0_BASE=0x3f8
-
-## Load payload using filo
-option CONFIG_IDE=1
-option CONFIG_FS_STREAM=1
-option CONFIG_FS_EXT2=1
-option CONFIG_FS_ISO9660=1
-option CONFIG_FS_FAT=1
-option AUTOBOOT_CMDLINE="hdc1:/vmlinuz"
-
-# LinuxBIOS must fit into 128KB
-option ROM_IMAGE_SIZE=131072
-option ROM_SIZE={ROM_IMAGE_SIZE+PAYLOAD_SIZE}
-option PAYLOAD_SIZE=262144
-
-# Set stack and heap sizes (stage 2)
-option STACK_SIZE=0x10000
-option HEAP_SIZE=0x10000
 
 # Sandpoint Demo Board
 romimage "normal"
@@ -92,8 +26,6 @@ romimage "normal"
 	option _RAMSTART=0x00100000
 
 	option CONFIG_SANDPOINT_ALTIMUS=1
-
-	mainboard motorola/sandpoint
 end
 
 buildrom ./linuxbios.rom ROM_SIZE "normal"