git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@10288 6f19259b-4bc3-4df7-8a09-765794883524

MdeModulePkg/Include/Guid/LoadModuleAtFixedAddress.h

@@ -28,7 +28,7 @@ extern EFI_GUID gLoadFixedAddressConfigurationTableGuid;
 
 typedef struct {
   EFI_PHYSICAL_ADDRESS    DxeCodeTopAddress;   ///< The top address below which the Dxe runtime code and below which the Dxe runtime/boot code and PEI code.
-  EFI_PHYSICAL_ADDRESS    SmramBase;                      ///< SMM RAME base. build tool will assigned an offset relative to SMRAM base for SMM driver.
+  EFI_PHYSICAL_ADDRESS    SmramBase;           ///< SMRAM base address. The build tool assigns an offset relative to the SMRAM base for a SMM driver.
 } EFI_LOAD_FIXED_ADDRESS_CONFIGURATION_TABLE;
 
 #endif

MdeModulePkg/Include/Library/IpIoLib.h

@@ -530,9 +530,8 @@ IpIoFindSender (
   @param[in]   IcmpError             IcmpError Type.
   @param[in]   IpVersion             The version of the IP protocol to use,
                                      either IPv4 or IPv6. 
-  
+  @param[out]  IsHard                If TRUE, indicates that it is a hard error.
-  @param[out]  IsHard                Whether it is a hard error.
+  @param[out]  Notify                If TRUE, SockError needs to be notified.
-  @param[out]  Notify                Whether it need to notify SockError.
 
   @return The ICMP Error Status, such as EFI_NETWORK_UNREACHABLE.
 

MdeModulePkg/Include/Library/NetLib.h

@@ -507,7 +507,7 @@ NetGetUint32 (
   byte stream.
 
   @param[in, out]  Buf          The buffer in which to put the UINT32.
-  @param[in]      Data          The data to put.
+  @param[in]       Data         The data to be converted and put into the byte stream.
 
 **/
 VOID
@@ -1097,17 +1097,18 @@ NetLibGetMacString (
 
   The underlying UNDI driver may or may not support reporting media status from
   GET_STATUS command (PXE_STATFLAGS_GET_STATUS_NO_MEDIA_SUPPORTED). This routine
-  will try to invoke Snp->GetStatus() to get the media status. Iif media is already
+  will try to invoke Snp->GetStatus() to get the media status. If media is already
-  present, it returns directly. If media  isnot present, it will stop SNP and then
+  present, it returns directly. If media is not present, it will stop SNP and then
   restart SNP to get the latest media status. This provides an opportunity to get 
   the correct media status for old UNDI driver, which doesn't support reporting 
   media status from GET_STATUS command.
   Note: there are two limitations for the current algorithm:
   1) For UNDI with this capability, when the cable is not attached, there will
      be an redundant Stop/Start() process.
-  2) For UNDI without this capability, when the cable is attached, the UNDI
+  2) for UNDI without this capability, in case that network cable is attached when
-     initializes while unattached. Later, NetLibDetectMedia() will report
+     Snp->Initialize() is invoked while network cable is unattached later,
-     MediaPresent as TRUE, causing upper layer apps to wait for timeout time.
+     NetLibDetectMedia() will report MediaPresent as TRUE, causing upper layer
+     apps to wait for timeout time.
 
   @param[in]   ServiceHandle    The handle where network service binding protocols are
                                 installed.
@@ -1868,8 +1869,8 @@ NetbufQueCopy (
   );
 
 /**
-  Trim Len bytes of data from the queue header and release any net buffer
+  Trim Len bytes of data from the buffer queue and free any net buffer
-  that is trimmed wholely.
+  that is completely trimmed.
 
   The trimming operation is the same as NetbufTrim but applies to the net buffer
   queue instead of the net buffer.

MdeModulePkg/Library/DxeIpIoLib/DxeIpIoLib.c

@@ -2013,9 +2013,8 @@ IpIoFindSender (
   @param[in]   IcmpError             IcmpError Type.
   @param[in]   IpVersion             The version of the IP protocol to use,
                                      either IPv4 or IPv6. 
-  
+  @param[out]  IsHard                If TRUE, indicates that it is a hard error.
-  @param[out]  IsHard                Whether it is a hard error.
+  @param[out]  Notify                If TRUE, SockError needs to be notified.
-  @param[out]  Notify                Whether it need to notify SockError.
 
   @return ICMP Error Status, such as EFI_NETWORK_UNREACHABLE.
 

MdeModulePkg/Library/DxeNetLib/DxeNetLib.c

@@ -901,7 +901,7 @@ NetGetUint32 (
   byte stream.
 
   @param[in, out]  Buf          The buffer to put the UINT32.
-  @param[in]      Data          The data to put.
+  @param[in]       Data         The data to be converted and put into the byte stream.
 
 **/
 VOID
@@ -2158,9 +2158,10 @@ NetLibGetMacString (
   Note: there will be two limitations for current algorithm:
   1) for UNDI with this capability, in case of cable is not attached, there will
      be an redundant Stop/Start() process;
-  2) for UNDI without this capability, in case cable is attached in UNDI
+  2) for UNDI without this capability, in case that network cable is attached when
-     initialize while unattached latter, NetLibDetectMedia() will report
+     Snp->Initialize() is invoked while network cable is unattached later,
-     MediaPresent as TRUE, this cause upper layer apps wait for timeout time.
+     NetLibDetectMedia() will report MediaPresent as TRUE, causing upper layer
+     apps to wait for timeout time.
 
   @param[in]   ServiceHandle    The handle where network service binding protocols are
                                 installed on.

MdeModulePkg/Library/DxeNetLib/NetBuffer.c

@@ -1556,8 +1556,8 @@ NetbufQueCopy (
 
 
 /**
-  Trim Len bytes of data from the queue header, release any of the net buffer
+  Trim Len bytes of data from the buffer queue and free any net buffer
-  whom is trimmed wholely.
+  that is completely trimmed.
 
   The trimming operation is the same as NetbufTrim but applies to the net buffer
   queue instead of the net buffer.