Add support process Port Speed field value of PORTSC according to
Supported Protocol Capability (define in xHCI spec 1.1)
REF: https://bugzilla.tianocore.org/show_bug.cgi?id=3914
The value of Port Speed field in PORTSC bit[10:13]
(xHCI spec 1.1 section 5.4.8) should be change to use this value to
query thru Protocol Speed ID (PSI) (xHCI spec 1.1 section 7.2.1)
in xHCI Supported Protocol Capability and return the value according
the Protocol Speed ID (PSIV) Dword.
With this mechanism may able to detect more kind of Protocol Speed
in USB3 and also compatiable with three kind of speed of USB2.
Cc: Jenny Huang <jenny.huang@intel.com>
Cc: More Shih <more.shih@intel.com>
Cc: Hao A Wu <hao.a.wu@intel.com>
Cc: Ray Ni <ray.ni@intel.com>
Signed-off-by: Ian Chiu <Ian.chiu@intel.com>
Reviewed-by: Hao A Wu <hao.a.wu@intel.com>
Current hard code Usb2Hc.XXXRevision may be not accurate.
This patch updates code to assign Usb2Hc.XXXRevision based on
SBRN (Serial Bus Release Number, PCI configuration space offset
0x60) although there is no code consuming them.
Cc: Ruiyu Ni <ruiyu.ni@intel.com>
Cc: Hao Wu <hao.a.wu@intel.com>
Cc: Jian J Wang <jian.j.wang@intel.com>
Contributed-under: TianoCore Contribution Agreement 1.1
Signed-off-by: Star Zeng <star.zeng@intel.com>
Reviewed-by: Ruiyu Ni <ruiyu.ni@intel.com>
1.Port reset process may not be proper for some vendor's SS hubs. If the corresponding port shows the reset has been done by C_RESET bit we have to skip the whole reset process for attached devices.
2.Clean C_BH_RESET bit immediately to avoid usb timer entering too many times when 5 tiers hubs are connected.
3.Stop checking URB if there is an error happened.
4.Better error handling for fast hot-plug.
Signed-off-by: Feng Tian <feng.tian@intel.com>
Reviewed-by: Elvin Li <elvin.li@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@14889 6f19259b-4bc3-4df7-8a09-765794883524
1) XHCI host controller hw always provides more than 5 interrupters.
Now using interrupter 0 to accommodate all received events.
2) XHCI host controller hw always provides 32bytes context size.
Now it dynamically detect context size and construct it.
also solved several issues:
1) Divides 64byte width register access to two 32bit registers access because some XHCI chipsets cannot support a single 64bit access.
2) Remove halt host controller statement in UsbBusDriverBindingStop(). It has been done by host controller’s DriverBindingStop(). And XhciDriverBindingStop() need XHCI host controller is in running state because it need execute DISABLE_SLOT cmd to release h/w resource.
signed-off-by: erictian
Reviewed-by: li-elvin
git-svn-id: https://edk2.svn.sourceforge.net/svnroot/edk2/trunk/edk2@12785 6f19259b-4bc3-4df7-8a09-765794883524
