Use BasePeCoffLib PeCoffLoaderGetImageInfo() to check the PE/COFF image.
In V2, add specific ImageRead() to make sure the PE/COFF image content
read is within the image buffer.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Liming Gao <liming.gao@intel.com>
Reviewed-by: Jiewen Yao <jiewen.yao@intel.com>
Reviewed-by: Chao Zhang <chao.b.zhang@intel.com>
SubmitCommand() was checking the buffer size for ">=" Max size. This would
cause code to fail with "EFI_INVALID_PARAMETER" if a buffer was passed
that was the "max" size as indicated by the GetCapability() command.
Change to ">" to allow for maximum buffer size.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Bret Barkelew <brbarkel@microsoft.com>
Reviewed-by: Yao Jiewen <jiewen.yao@intel.com>
Reviewed-by: Chao Zhang <chao.b.zhang@intel.com>
Reduce several DEBUG messages verbosity from INFO to VERBOSE, so that will not see debug message around each driver loading when TPM 2.0 part present.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Derek Lin <derek.lin2@hpe.com>
Reviewed-by: Chao Zhang <chao.b.zhang@intel.com>
Reviewed-by: Yao Jiewen <jiewen.yao@intel.com>
This patch updated final event log calculation based on
TCG EFI PROTOCOL rev9, 7.1.2 "All options implementation".
The previous logic is to save event to final event log
once GetEventLog() is called. 7.1.1 shows that we should
save event log to both normal even log area and final event
log area after GetEventLog() is called.
And there is no need to record TCG12 format log to final
event log area, and normal event log area can be BootServices
memory because OS will not access it directly.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: "Yao, Jiewen" <jiewen.yao@intel.com>
Reviewed-by: "Zhang, Chao B" <chao.b.zhang@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@19661 6f19259b-4bc3-4df7-8a09-765794883524
Previously, NumberOfPCRBanks is calculated based on TPM
capability. However, there might be a case that TPM hardware
support 1 algorithm, but BIOS does not support and BIOS
mask it via PCD. This causes the conflict between
HashAlgorithmBitmap and NumberOfPCRBanks.
So we move the NumberOfPCRBanks calculation based on
HashAlgorithmBitmap to make sure the data is consistent.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: "Yao, Jiewen" <jiewen.yao@intel.com>
Reviewed-by: "Zhang, Chao B" <chao.b.zhang@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@19660 6f19259b-4bc3-4df7-8a09-765794883524
TCG event log and TCG2 final event log area length can be configurable to meet platform event log
requirement.
PcdTcgLogAreaMinLen : 0x10000 based on minimum requirement in TCG ACPI Spec 00.37
PcdTcg2FinalLogAreaLen : 0x8000 based on experience value
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Chao Zhang <chao.b.zhang@intel.com>
Reviewed-by: Yao Jiewen <jiewen.yao@intel.com>
Reviewed-by: Qin Long <qin.long@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@19639 6f19259b-4bc3-4df7-8a09-765794883524
This is patch to remove smbios measurement in TCG driver. There will be other patch to add it in Smbios driver.
The problem of current SMBIOS measurement is:
1) TCG drivers do not support SMBIOS3.0 table.
2) TCG drivers do not follow TCG platform spec on: "Platform configuration information that is automatically updated,
such as clock registers, and system unique information, such as asset numbers or serial numbers,
MUST NOT be measured into PCR [1], or any other PCR."
So we decide to move Smbios measurement from TCG drivers to Smbios driver.
Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: "Yao, Jiewen" <jiewen.yao@intel.com>
Reviewed-by: "Zhang, Chao B" <chao.b.zhang@intel.com>
git-svn-id: https://svn.code.sf.net/p/edk2/code/trunk/edk2@18677 6f19259b-4bc3-4df7-8a09-765794883524
