Update .clang-format for LLVM 14.0, available on Ubuntu 22.04.
There is still plenty that clang-format sucks at or does wrong, so
either add some more blocks to disable it, or just put up with it.
Signed-off-by: Tim Crawford <tcrawford@system76.com>
If the board is on AC power when powered off the EC will not reset, and
WLAN power will not be enabled on next boot. Move enabling WLAN from
`board_init()` to `power_on()`.
Fixes: be4659a0cb ("Set wireless power at init and power off")
Signed-off-by: Tim Crawford <tcrawford@system76.com>
Add a new wireless object for controlling WLAN power state. Change the
power sequence to enable WLAN at board init and disable it at power off.
Newer galp5 units sold to customers have an issue where they do not
fully power off. This is apparently somehow caused by `WLAN_PWR_EN`.
The unit received for development do not have this issue.
Signed-off-by: Tim Crawford <tcrawford@system76.com>
EC_VARIANT is only used on AVR as a parameter to avrdude.
Replace its use on ITE with 2 choices:
- CONFIG_EC_ITE_IT8587E
- CONFIG_EC_ITE_IT5570E
Replace the EC defines with a matching define for the variable.
Replace use of wildcard with list of source files to include. The `-y`
suffix is added, but has no significance since conditional compilation
has not been added yet.
Signed-off-by: Tim Crawford <tcrawford@system76.com>
Split the EC define into base and variant. Merge the 3 ATmega chips as
atmega, and the 2 ITE chips as ite.
Tested that the generated files are identical.
Signed-off-by: Tim Crawford <tcrawford@system76.com>
Fix all smart charger values by having boards provide the RSENSE values
and perform the register calculations in the code.
The galp3-c, galp5, gaze16, and gaze17 do not seem to have the same
behavior as the rest of the boards, and further investigation is needed.
In the mean time, reduce their charge current values to preserve current
behavior.
Ref: OZ26786-DS v1.0
Ref: bq24780S Rev. C datasheet
Signed-off-by: Tim Crawford <tcrawford@system76.com
Logic for changing power limit is the same for all boards with GPUs. It
is still called from board_event() instead of in power_event() to
maintain the current behavior of checking every main cycle.
Signed-off-by: Tim Crawford <tcrawford@system76.com>
* SMOOTH_FANS, SMOOTH_FANS_UP, SMOOTH_FANS_DOWN build flags to smooth fan speed changes.
Defaults 40, set SMOOTH_FANS=0 to disable and keep sharp fan speed changes
* fix for ACPI CPU temperature
* allow for a floor to be set for fan smoothing and specifically configure oryp6/7 to start smoothing at 25% to mitigate fan buzzing below 25%
* update default config values for fans
* update all devices to use defaults for heatup, cooldown, update galp5 fan curves
* Decrease default cooldown time from 20 to 10
Co-authored-by: Jacob Kauffmann <jacob@system76.com>
